System Data
Physical/Thermal Data
| Specific Gravity |
1.16 g/cc |
| Glass Transition Temperature |
188°C |
Mechanical Properties
| Elastic Modulus |
68,480 psi |
| Yield Stress |
1,090 psi |
| Failure Stress |
1,090 psi |
| Ultimate Elongation |
102% |
Handling and Processing Instructions
General Requirements
 |
Light Sensitive Material - Avoid Unintentional
Exposure to Light.
|
|
Process at 70° C - Must
be Thoroughly Mixed Before Processing. Store at 70°
F
to Maintain Mixture Homogeneity. If Separation Occurs (white flakes in
mixture), Heat to 70° C and Tumble to Mix.
|
|
Material is Sensitive to Freons - Do Not Expose
Cured Coatings to Freons.
|
Health Information
|
Mixture is Irritant.
|
|
Avoid Eye and Skin Contact - Wear Protective
Clothing.
|
Shelf Life
|
One year unless exposed to heat or light.
|
Equipment Requirements
|
UV Light Source - Fusion UV Curing Systems
(301/251-0300) Model F300 or Equivalent.
|
|
Protected Enclosure for UV Exposures.
|
|
Spray Gun - BINKS Model 115 with 78S tip and 8 oz
fluid cup or Equivalent. Propel with Nitrogen.
|
|
Clean Bench or Fume Hood to Control Dust and Fumes.
|
|
Antistatic Materials for Handling Electronic
Components.
|
Spray Coating Procedures
|
Filter AT-924 Epoxy at 70°
C into Clean Spray Gun Reservoir.
|
|
Surface Preparation - Surfaces to be Coated Must be
Contaminant Free. Clean with an Appropriate Solvent. Where Possible, Etching
or Abrading Surface Will Promote Adhesion.
|
|
Spray Coating - Spray with Epoxy at 70°
C with 30 psi Nitrogen. Where Possible, Spray onto Warm Substrate for Best
Results. Avoid Exposure of Coated Substrate to Dust or Other Contaminants
Prior to UV Cure.
|
|
UV Cure - Expose to High Intensity UV Light Source
for 60 Seconds. Light Must Reach into All Coated Areas - Rotate Substrate or
Expose in a Reflective Enclosure.
|
|
Postcure - Expose UV Cured Coating at 70°
C for 2-4 Hours in a Clean Oven to Complete Cure. May be postcured at 125°
C for higher temperature applications.
|
|
