Light Sensitive Material - Avoid Unintentional Exposure to Light.

 Process at 70° C - Must be Thoroughly Mixed Before Processing. Store at 70° F to Maintain Mixture Homogeneity. If Separation Occurs (white flakes in mixture), Heat to 70° C and Tumble to Mix.

 Material is Sensitive to Freons - Do Not Expose Cured Coatings to Freons.

 Mixture is Irritant.

 Avoid Eye and Skin Contact - Wear Protective Clothing.

 One year unless exposed to heat or light.

 UV Light Source - Fusion UV Curing Systems (301/251-0300) Model F300 or Equivalent.

 Protected Enclosure for UV Exposures.

 Spray Gun - BINKS Model 115 with 78S tip and 8 oz fluid cup or Equivalent. Propel with Nitrogen.

 Clean Bench or Fume Hood to Control Dust and Fumes.

 Antistatic Materials for Handling Electronic Components.

 Filter AT-924 Epoxy at 70° C into Clean Spray Gun Reservoir.

 Surface Preparation - Surfaces to be Coated Must be Contaminant Free. Clean with an Appropriate Solvent. Where Possible, Etching or Abrading Surface Will Promote Adhesion.

 Spray Coating - Spray with Epoxy at 70° C with 30 psi Nitrogen. Where Possible, Spray onto Warm Substrate for Best Results. Avoid Exposure of Coated Substrate to Dust or Other Contaminants Prior to UV Cure.

 UV Cure - Expose to High Intensity UV Light Source for 60 Seconds. Light Must Reach into All Coated Areas - Rotate Substrate or Expose in a Reflective Enclosure.

 Postcure - Expose UV Cured Coating at 70° C for 2-4 Hours in a Clean Oven to Complete Cure. May be postcured at 125° C for higher temperature applications.